4000/500 TON BLH HYDRAULIC EXTRUSION PRESS w/PIERCER [10698]

MACHINE# 10698

SPECIFICATIONS:

Manufacturer ............. BLH
Capacity ................. 4000/500 Tons
Type ..................... 4-post design, air over water

Stroke ................... 66"
Billet Capacity .......... 8" - 12"
Maximum billet length .... 24"
Main cylinder ............ 53-1/4" diameter, 54" stroke
Piercer cylinder.......... 17-1/2" diameter
Piercer return(side)cyl .. 11-3/4" diameter
Container close cyl....... 10-1/2" diameter
Tool stroke cylinder ..... 8" diameter (estimated)

Pullback ................. 310-ton pullback
Working pressure ......... 3600 psi
Press rating ............. 4000 ton + 500 ton piercer @4250 psi
Extrusion speed .......... 2" per second +/- .5" (typical)

Total Length of press .... 59'-2", without runout
Runout Length ............ 250' (Included with Press)
Maximum Height............ 15'-2" above floor
Extrusion axis ........... 36" above floor
Billet conveyor ..........

Electrical ............... 120 volts 60 Hz control power
460 volts 3 phase 60 Hz motors, except 4160 volts 3 phase 60 Hz
for high pressure pump motors.
High pressure pumps ...... (3) Aldrich, 450 HP each.
Fluid tanks .............. (2) 2,500 gallon hydraulic fluid tanks

Billet Heaters:

Two (2) Ajax Magnethermic billet heaters in parallel at the BLH press
(Right hand & Left hand)
Supply to both heaters together is 4160 volts single phase, 60 Hz, 270 amps
Each heater is rated at 1100 kVA peak input, 880 peak kW
Each heater is capable to heat 9"-10" Dia. and 10"-24" long copper billets
Each heater is rated at 32.5 pieces per hour of copper billets or 17.5 pieces
per hour of 90-10 cupronickel or 16.5 pieces per hour of 70-30 cupronickel
Maximum copper billet temperature 1820 F (CuNi is heated higher)
175 GPM of water is needed per heater to remove 1.750,000 Btu/Hr./heater
Billet Conveyor included at both entry to the furnace and exit to the press.

Approximate Weight: ....... 250 Tons (Main cylinder is estimated 25-30 tons

Press Also Includes:

Three (3) containers, with liners for 10" billets.
- One container will need billet removed.
Over 100 extrusion mandrels
Thirteen (13)-cleanout rings
Four (4)- mandrel holders
Four (4)-dummy blocks
One (1)- sub bolster
Twenty four (24)- Die holders
All available spare parts dedicated to the press and billet furnace.

Still Installed in Plant.

**PRICE QUOTED IS EX WORKS AS IS WHERE IS SUBJECT TO PRIOR SALE**

**ALL SPECIFICATIONS ARE SUBJECT TO VERIFICATION BY PURCHASER**