12 1/2" WATERBURY FARREL ZR 34-12-1/2" 20 HIGH SENDZIMIR ROLLING MILL (7881)

SPECIFICATIONS:

MANUFACTURER WATERBURY FARREL
TYPE 20-HI REVERSING Z-MILL
MODEL No.: ZR34-12 1/2
MAXIMUM STRIP WIDTH 317 MM (12.5")

CURRENT THICKNESSES *
- MAXIMUM ENTRY 1.2 MM (0.050")
- MINIMUM FINISH 0.0127MM (0.0005")

* NOTE: MILL ITSELF CAN GO THICKER & THINNER DEPENDING ON ALLOY

MAXIMUM TENSION 2500 KG @ 91 M/MIN.
(5500 LBS. @ 300 FPM)
SPEED RANGE 45 - 90 M/MIN. (150 - 300 FPM)
MAIN DRIVE MOTOR 40 HP, 333/666 RPM
WINDER MOTORS (2) 50 HP, 41/82 RPM
DRIVE CONTROLS EUROTHERM ELECTRONIC D.C. DRIVES,
INSTALLED 2003
AUTOMATIC GAUGE CONTROL (AGC)
MANUFACTURER VOLLMER
MODEL No. VBM 1076
ELECTRONICS VMF ELECTRONICS, NEW 2003

MILL

WORK ROLLS NOMINAL DIA. .400"
1ST INTERMEDIATE ROLLS NOMINAL DIA. .850"
2ND INTERMEDIATE ROLLS:
- DRIVE ROLLS NOMINAL DIA. 1.725"
- IDLER ROLLS NOMINAL DIA. 1.624"
BACKING BEARING DIA. 3.000"
- WIDTH 1.820"
- NUMBER REQUIRED 40

WINDERS

SOLID BLOCKS ON RAILS WITH HYDRAULICALLY OPERATED HOLDING CLAMPS AND DRIVE
DISCONNECTORS. BOTH REELS ARE ARRANGED FOR 1/2" EACH WAY AXIAL MANUAL
ADJUSTMENT.

SOLD BLOCK DIA. 14.000"
COIL MAXIMUM DIA. 28"
GRIPPERS ALL FLUSH TYPE

MILL LUBRICATION

MILL LUBRICATION SYSTEM CAPACITY 20 GPM
OIL RECEIVING TANK CAPACITY 400 GAL.
OIL MINERAL 50-100 SSU @ 100 DEG. F.

FILTRATION (1) 1 FILTER, FULL FLOW, 2 CARTRIDGES, PLEATED-PAPER TYPE
(2) 1 FILTER, 5 GPM, RECIRCULATING, CLAY TYPE

GEAR LUBRICATION

PINION STAND SPLASH LUBRICATION
OIL USE E.P. ADDITIVES
VISCOSITY 700-1000 @ 100 DEG. F.
REDUCERS -
FOR MILL & WINDER MOTOR REDUCERS, FOLLOW MANUFACTURER'S RECOMMENDATIONS.

HYDRAULICS

THIS SYSTEM IS SERVING MILL AND WINDERS
TANK CAPACITY 60 GAL.
MOTOR (ONE) 3 HP, 1200 RPM
DUAL PUMP (ONE)
- LARGE VOLUME 3 GPM @ 500 PSI
- SMALL VOLUME 1.9 GPM @ 1000 PSI

* * * ALL SPECIFICATIONS ARE SUBJECT TO BUYER'S VERIFICATION * * *