7/8" X 4" X 6" STANAT MODEL TA-215 2/4 HI ROLLING MILL (7487)

MACHINE 7487

MANUFACTURER: STANAT MANUFACTURING

MODEL: TA-215

TYPE MILL: 2/4 HIGH REVERSING ROLLING MILL
BACK UP ROLL DRIVEN

WORK ROLL SIZE: 7/8" X 6" (22.225mm X 152.4mm)
BACK UP ROLL SIZE: 4" X 6" (101mm X 152.4mm)

BACK UP ROLL HEATERS: MILL IS EQUIPPED WITH ROLL HEATERS ON THE BACK
UP ROLLS. TEMPERATURE IS CONTROLLED USING
POWERSTAT VARIABLE TRANSFORMER MFG BY SUPERIOR
ELECTRIC COMPANY.
BEARINGS:
-BACK UP ROLLS ROLLER BEARINGS
-WORK ROLLS ROLLER NEEDLE BEARINGS

BEARING LUBRICATION: FORCED OIL SYSTEM
-ON BOARD TANK AND PUMP SET UP FEEDING ROLL
CHOCK BEARINGS

SCREWDOWNS: DUAL HANDWHEEL WITH ELECTRIC ASSIST FOR FAST
COARSE ADJUSTMENT
-1/2 HP 1725 RPM AC MOTOR
-115/230 VOLT

MILL DRIVE MOTOR: 10 HP DC 1750/2300 RPM

MILL DRIVE: RELIANCE MAX PAK VS SOLID STATE VARIABLE SPEED
DC REVERSING DRIVE WITH DYNAMIC BRAKING
MODEL NUMBER 10C395
S/N V1 AZ 10639D
S/O 1GA 786 323
RATED FOR 10 HP
VOLTAGE: 230 VOLT 3 PHASE 60 HERTZ
AMPS: 36
ARMATURE VOLTAGE: 240
FIELD VOLTAGE: 150
APPROXIMATE SPEED: 0 TO 150 FPM
SPEED READOUT: MILL EQUIPPED WITH SEPARATE RED LION DIGITAL
READOUT. SPEED SIGNAL ORIGINATED FROM A RED LION
SHAFT ENCODER COUPLED VIA BELT TO THE UPPER
DRIVE SPINDLE
-RED LION MODEL DT3D DIGITAL FPM READOUT
-RED LION MODEL 4601200 SHAFT ENCODER
-1200 PULSES PER REVOLUTION
-12 VDC

COILERS: DUAL MILL DRIVEN COILER SET UP
-RIGHT SIDE POSITIVELY DRIVEN BY AC MOTOR
-TENSION CONTROLLED ON BOTH SIDES VIA PNEUMATIC
WITCHITA CLUTCHES
-SHAFT DIAMETERS 1 7/8"
IT APPEARS THAT THE MILL WAS PRIMARILY USED AS A
SINGLE DIRECTION MILL (LEFT TO RIGHT) USING THE
AC MOTOR ON THE RIGHT SIDE. HOWEVER, WITH BOTH
LEFT AND RIGHT SHAFTS COUPLED TO THE MILL DRIVE
SPINDLE VIA THE PNEUMATIC CLUTCHES, IT APPEARS
THAT BOTH SIDES COULD BE DRIVEN AS IS SEEN WITH
TYPICAL COILERS OF THIS NATURE.

EQUIPPED WITH: BANNER ENGINEERING CORP LIGHT CURTAIN UNITS

**PRICE QUOTED IS EX-WORKS AS IS WHERE IS SUBJECT TO PRIOR SALE**

**ALL SPECIFICATIONS ARE SUBJECT TO VERIFICATION BY CUSTOMER**