1/2" - 1 1/4" SHUSTER TUBE STRAIGHTEN & CUT LINE (6001)

SPECIFICATIONS:
MANUFACTURER: THE SHUSTER METTLER CORP.
TYPE: CUT-TO-LENGTH LINE FOR TUBE
CAPACITY: 1/4" MIN. TO 1" MAX. O.D.
TAKEN OUT OF SERVICE: 1996
DIRECTION OF TRAVEL: RIGHT-TO-LEFT

THE LINE CONSISTS OF THE FOLLOWING:

PAY-OFF:
TYPE: CARROUSEL
NON-DRIVEN
CONFIGURATION: VERTICAL (EYE TO THE SKY)
MIN. TUBE COIL DIAMETER: 42" O.D.
MAX. TUBE COIL DIAMETER: 92" O.D.
FLOOR SPACE: 10 FT. x 10 FT.

STRAIGHTENER:
MANUFACTURER: THE SHUSTER METTLER CORP.
MODEL NO.: 3GRS
NO. OF ROLLS: 12
CONFIGURATION: TWO PLANE
ROLL SIZE: 4" DIA. x 1 1/4" FACE
DRIVE MOTOR: 5 HP, 208-220/440 VOLTS, 1745 RPM, 3 PH., 60 HZ
NO. OF ROLLS ADJUSTABLE: 6 (3 VERTICAL, 3 HORIZONTAL)
CAPACITY: 1/2" - 1 1/4" O.D.

CUT-OFF SHEAR:
MANUFACTURER: ROBINTECH HOLMES
TYPE: AIR-ACTUATED FLYING SHEAR
RUNOUT TABLE: TO BE SUPPLIED BY PURCHASER
LENGTH RANGE: ADJUSTABLE TO CUSTOMER'S SPECIFICATIONS

NOTE: THIS LINE CONSISTS OF THREE COMPONENTS WHICH MUST BE TIED TOGETHER
ELECTRICALLY AND MECHANICALLY BY THE PURCHASER. THE PAYOFF IS LOCATED
IN ARKANSAS. THE STRAIGHTENER AND SHEAR ARE LOCATED IN CONNECTICUT.

********* ALL SPECIFICATIONS ARE SUBJECT TO VERIFICATION *********