50,000 LB. ABBEY LOMBARD 5 DIE HYDRAULIC DRAWBENCH (5993)

MANUFACTURER: ABBEY-LOMBARD CORPORATION
TYPE: HYDRAULIC DRAWBENCH FOR TUBE OR BAR
RATED CAPACITY: 50,000 LB. PULL

NO. OF TUBES DRAWN PER CYCLE: 1, 2, 3, 4, OR 5
(NOTE: EQUIPPED WITH DIE HOLDERS AND CARRIAGE FOR DRAWING 2 OR 5 TUBES)

MAX. INCOMING TUBE LENGTH: 100 FT.
MAX. FINISH TUBE LENGTH: 122 FT.

TYPE OF DRAW: DUAL CABLE
(NOTE: NEW CABLE WAS RECENTLY INSTALLED)

TYPE OF FEED SYSTEM: BARREL ROLLOVER WITH PINCH ROLL FEED
TYPE OF PUSHER INTO DIE: PNEUMATIC
TYPE OF TUBE DISCHARGE: SIDE DISCHARGE INTO RACK SYSTEM

DRIVE MOTOR ON HYDRAULIC PUMP: 300 HP, 885 RPM, 440 VOLT, RELIANCE
HYDRAULIC PUMP MANUFACTURER: OILGEAR CORPORATION

COMPLETE WITH CONTROLS AND HYDRAULICS

STATUS: NEW IN 1967. TAKEN OUT OF SERVICE IN 1999. STILL INSTALLED WITH
POWER TO THE CONTROLS. MANY SPARE PARTS INCLUDED.

NOTE: THIS DRAWBENCH IS INSTALLED NEXT TO A 28,000 LB. LOMBARD 5 DIE DRAWBENCH
AND CUT-OFF SAW FOR EASE IN MATERIAL HANDLING. THE SECOND DRAWBENCH AND
SAW ARE QUOTED SEPARATELY BUT MAY BE PURCHASED AS A PACKAGE.

********* ALL SPECIFICATIONS ARE SUBJECT TO VERIFICATION *********