36" X 5" LOOPCO SLITTING LINE (5847)

MANUFACTURER: LOOPCO INDUSTRIES INC

UNCOILER:
MANDREL: 16/20" x 37" (406/508mm x 939mm)
MANDREL EXPANSION: HYDRAULIC
FEED UP MOTOR: HYDRAULIC
BACK TENSION: WICHITA AIR CLUTCH/BRAKE
EQUIPPED WITH SLIDING BASE

SLITTER:
ARBOR SIZE: 37" X 5" (939mm X 127mm)
ARBOR ADJUSTMENT: PARALLEL/CAM
SLITTER KNIFE OD: 9" (228mm
SLITTER SPACER OD: 7" (178mm)
SLITTER DRIVE:
FEED UP DRIVE: 5HP GENERAL ELECTRIC INDUCTION, 3 PHASE
60 HZ, 230/460 VOLTS, 14.2/7.1 AMPS, 1745 RPM
INTO WINSMITH SPEED REDUCER RATIO 15, 1800 RPM
INPUT, OUTPUT TORQUE 1770 INCH LBS, MODEL
6MCTW, SERIAL #B563-2D-56
DRIVE MODE MOTOR: 15HP CUTLER HAMMER, 1150/2000 RPM, 500 VOLTS,
SHUNT WOUND
GEAR REDUCER: FALK ENCLOSED GEAR DRIVE, MODEL 5DC2-04AS1
RPM 1150/2000, OUTPUT RPM 155/266, RATIO 4.929
ENTRY SIDE GUIDE ROLLS

LOOPING PIT FEED UP TABLE

PRESSURE BOARD TENSION STAND

RECOILER
MANDREL SIZE: 16" X 42" (406mm X 1066mm) SHOES FOR 20" ID
(508mm)
DRIVE MOTOR: 50 HP GENERAL ELECTRIC DC, 500 VOLTS,
600/2000 RPM
HYDRAULIC PUSH OFF
GEAR REDUCER: HORSBURGH & SCOTT, SIZE LD-2800, RATIO 16.76
INPUT RPM 500, HP RATING 55
OVER ARM SEPARATOR

LINE SPEED: 500 FPM CONSTANT, 500 FPM BARE DRUM SPEED WITH
SPEED INCREASE DUE COIL BUILD UP
COIL WEIGHTS: 20,000 POUNDS
EQUIPPED WITH TOOLING
MATERIAL PROCESS DIRECTION: RIGHT TO LEFT