24" x 4 1/8" RUESCH No. 146 SLITTING LINE (5679)

MANUFACTURER: RUESCH MACHINE CORP.
YEAR OF MANUFACTURER: 1975
MODEL NO.: 146
DIRECTION OF FEED: RIGHT-TO-LEFT
MODE OF OPERATION: PULL-THROUGH

LINE SPEED: BASIC: 0-125/350 FPM - 14/36" DIA.
350 FPM @ 36" O.D. COIL
125 FPM @ 14" O.D. COIL

DRIVE MOTOR: BASIC: 60 HP CONSTANT TORQUE D.C.

CAPACITY RATING: 20 CUTS IN .050" STEEL
6 CUTS IN .090" STEEL
3 CUTS IN .125" STEEL

PAYOFF:
SERIAL NO.: N2676 5992
COIL WEIGHT: 6000 LBS.
MANDREL EXPANSION RANGE: 15 1/2" - 20 1/2" DIA.
MANDREL FACE: 30" APPROX.
MANDREL ACTUATION: HYDRAULIC
TYPE OF BRAKE: FAWICK WATER COOLED AIR BRAKE
SLIDING BASE
POSITIONAL RANGE: +/- 3"
METHOD OF POSITIONING: HYDRAULIC W/P.B. MANUAL CONTROL

SLITTER:
MANUFACTURER: RUESCH MACHINE CO.
MODEL NO.: 146
ARBOR WIDTH: 26" NOMINAL
ARBOR DIAMETER: 4 1/8"
CUTTER DIAMETER: 7-1/2"
SPACER DIAMETER: 5 1/4" I.D. x 7-3/8" O.D.
STRIPPING METHOD: STEEL RINGS & RUBBER COLLARS
STRIPPING RING DIMENSION: 8 1/2" x 7 3/4"
ENTRY TABLE: SWING-OUT TYPE W/FLAT GUIDES
EXIT ROLLS: YES
THREADING MOTOR: 5 HP, 1725 RPM, 3 PH., 60 HZ., INTO
HELICAL GEAR MOTOR, W/105.9 TO 1 RATIO
THREADING SPEED: 30 FPM
MAIN DRIVE: NONE
ENTRY TENSION STAND: 5-1/2" DIA. x 37" FACE ROLLS
MANUAL ARBOR ADJUSTMENTS

SCRAP WINDER:
MANUFACTURER: RUESCH MACHINE CO.
MODEL NO.: 254
DRUM DIAMETER: 16"
DRUM FACE: 18" APPROX.
WEIGHT CAPACITY: 500 LBS.
DRIVE MOTOR: HYDRAULIC
TRAVERSING GUIDE: YES

REWINDER:
MANUFACTURER: RUESCH MACHINE CO.
MODEL NO.: 247
DRUM DIAMETER: 14"
DRUM FACE: 32" APPROX.
TYPE OF DRUM: MANUALLY COLLAPSIBLE
OVERARM SEPARATOR
COIL WEIGHT CAPACITY: 6000 LBS.
DRIVE: 60 H.P., 500 VOLTS, 1760 RPM, 97 AMPS
W/WER SCR CONTROLS
GEAR-IN DIAMETER: 14"
COIL STRIPPER: HYDRAULIC DRIVE INTO GEARBOX W/57.29 TO 1 RATIO

HYDRAULIC UNIT:
MANUFACTURER: LINCOLN MFG. CO.
DRIVE MOTOR: 7.5 H.P., 230/460 VOLTS, 3 PH., 60 HZ.

UTILITIES REQUIRED:
ELECTRICS: 460 VOLTS, 3 PH., 60 HZ., & 115 V.
AIR: 60 PSI
HYDRAULICS: SELF-CONTAINED W/MACHINE
WATER: YES

LINE IS EQUIPPED WITH TOOLING.